-
My ToshibaSemicon
- General Top View
-
SEMICONDUCTOR View
-
Applications
Body Electronics
xEV
In-Vehicle Infotainment
Advanced Driver-Assistance Systems (ADAS)
Chassis
Infrastructure
BEMS/HEMS
Factory Automation
Commercial Equipment
IoT Equipment
Healthcare
Wearable Device
Mobile
Computer Peripherals
-
Products
Products
-
Design & Development
Design & Development
Innovation Centre
At the Toshiba Innovation Centre we constantly strive to inspire you with our technologies and solutions. Discover how to place us at the heart of your innovations.
-
Knowledge
Knowledge
Highlighted Topics
Further Materials
Other
- Where To Buy View
-
- STORAGE View
- COMPANY View
- Part Number Search
- Cross Reference Search
- Keyword Search
- Parametric Search
- Stock Check & Purchase
This webpage doesn't work with Internet Explorer. Please use the latest version of Google Chrome, Microsoft Edge, Mozilla Firefox or Safari.
require 3 characters or more.
The information presented in this cross reference is based on TOSHIBA's selection criteria and should be treated as a suggestion only. Please carefully review the latest versions of all relevant information on the TOSHIBA products, including without limitation data sheets and validate all operating parameters of the TOSHIBA products to ensure that the suggested TOSHIBA products are truly compatible with your design and application.
Please note that this cross reference is based on TOSHIBA's estimate of compatibility with other manufacturers' products, based on other manufacturers' published data, at the time the data was collected.
TOSHIBA is not responsible for any incorrect or incomplete information. Information is subject to change at any time without notice.
require 3 characters or more.
Even ESD protection diodes fail to protect the DUP. What is the cause of its destruction?
In the event of an ESD strike, ESD protection diodes shunt much of the ESD energy to ground to protect the device under protection (DUP). However, the ESD protection diodes must be used properly so that the DUP is not degraded or destroyed by ESD.
As regards ESD protection diodes not working properly, there are two major causes.
- The selected ESD protection diodes are not suitable for protecting the DUP.
The higher the clamp voltage (VC) of ESD protection diodes, the greater the ESD energy applied to the DUP. So, you should not select ESD protection diodes with clamp voltage higher than necessary. If there are two ESD protection diodes with equal clamp voltage, selecting the one with lower dynamic resistance also helps improve the protection performance.
(For details, see the FAQ entry “How to select TVS diodes (ESD protection diodes).”)
How to select TVS diodes (ESD protection diodes)
- The layout of ESD protection diodes is not good.
Even the optimal ESD protection diodes do not provide sufficient protection performance unless they are laid out properly. Since an ESD pulse is very short, it is greatly affected by trace inductance. ESD protection diodes are inserted between a possible ESD entry point such as a connector and the DUP. ESD protection diodes should be placed as close as possible to the ESD entry points. In addition to the signal line to be protected, the ground trace should be short and wide and should not run through via holes.
(For details, see the FAQ entry “Board design considerations for TVS diodes (ESD protection diodes).”)
Board design considerations for TVS diodes (ESD protection diodes)
Related Links
For TVS diode (ESD protection diode) products, please refer to the following links.
