Photocouplers for IPM Interface

此光電耦合器支持5V和15V的電源電壓，適用於IPM（智能電源模組）的絕緣接口。輸出電路陣容包括集電極開路電路和圖騰柱電路。另外，可以根據每個公司IPM的輸入電路選擇圖騰柱電路組件的兩種類型，即變頻器邏輯輸出和緩衝邏輯輸出，例如高電平有效和低電平有效。

產品陣容

You can narrow down the search for applicable products by selecting specifications.

Data transfer rate (Mbps)
Output Interface
VCC/VDD (Min) (V)
VCC/VDD (Max) (V)
BVS (Min) (Vrms)
Results:

You can narrow down your search for applicable products by package type or number of pins.

unit:
5pin SO6

Package Size

W : 3.7 mm 0.15 inch
L : 7.0 mm 0.28 inch
H : 2.1 mm 0.083 inch
SO6L

Package Size

W : 3.84 mm 0.15 inch
L : 10 mm 0.39 inch
H : 2.1 mm 0.083 inch

All package dimensions are guaranteed in millimeters as mentioned on datasheet. Package dimension in inches is round to 2 significant digits converted with 1mm=0.0393701inch.

型號需要超過三個文字以上

About information presented in this cross reference

The information presented in this cross reference is based on TOSHIBA's selection criteria and should be treated as a suggestion only. Please carefully review the latest versions of all relevant information on the TOSHIBA products, including without limitation data sheets and validate all operating parameters of the TOSHIBA products to ensure that the suggested TOSHIBA products are truly compatible with your design and application.
Please note that this cross reference is based on TOSHIBA's estimate of compatibility with other manufacturers' products, based on other manufacturers' published data, at the time the data was collected.
TOSHIBA is not responsible for any incorrect or incomplete information. Information is subject to change at any time without notice.

Technical Articles

Isolators/Solid State Relays / Photocouplers / Photocouplers for IPM Interface

Support for high active and low active IPM
Our photocouplers for IPM interfaces are aligned with buffer output (output signal High with LED signal ON) for high active IPM, and inverter output (output Low with LED signal ON) for low active IPM.

Isolators/Solid State Relays / Photocouplers / Photocouplers for IPM Interface

Higher common-mode transient immunity (CMTI)
In order to ensure stable operation even when a large dV/dt is applied between the input and output of the photocoupler when the IPM is switched, the photo IC chip has a shield.

Isolators/Solid State Relays / Photocouplers / Photocouplers for IPM Interface

Response to higher speeds
The photocoupler for the IPM interface guarantees the maximum propagation delay time and enables high-speed transmission of PWM signals.

文件下載

名稱 日期

應用

Inverter/Servo
Such as low power consumption, miniaturization and robust operation are important in designing inverter/servo. Toshiba provides information on a wide range of semiconductor products suitable for power supply unit, motor driving circuit units, signal transmission units, etc., along with circuit configuration examples.
詳細資料
Mega-solar Inverters
Such as high efficiency and miniaturization are important in designing mega-solar inverter. Toshiba provides information on a wide range of semiconductor products suitable for inverter circuit unit, gate driving circuit unit, signal transmission unit, etc., along with circuit configuration examples.
詳細資料

聯繫我們

技術方面問題

聯絡我們

聯絡我們

常見問題

常見問答

採購 / 樣品 / IC可靠度 相關問題

線上庫存查詢跟購買

型號需要超過三個文字以上

keyword:

Disclaimer for External Link
Through this website you are able to proceed to the website of our distributors ("Third Party Website") which is not under the control of Toshiba Corporation and its subsidiaries and affiliates (collectively "Toshiba"). The Third Party Website is made available to you as a convenience only and you agree to use the Third Party Website at your own risk. The link of the Third Party Website does not necessarily imply a recommendation or an endorsement by Toshiba of the Third Party Website. Please be aware that Toshiba is not responsible for any transaction done through the Third Party Website, and such transactions shall be subject to terms and conditions which may be provided in the Third Party Website.

相關資訊

開啟新視窗