交叉搜尋
型號需要超過三個文字以上
About information presented in this cross reference
The information presented in this cross reference is based on TOSHIBA's selection criteria and should be treated as a suggestion only. Please carefully review the latest versions of all relevant information on the TOSHIBA products, including without limitation data sheets and validate all operating parameters of the TOSHIBA products to ensure that the suggested TOSHIBA products are truly compatible with your design and application.
Please note that this cross reference is based on TOSHIBA's estimate of compatibility with other manufacturers' products, based on other manufacturers' published data, at the time the data was collected.
TOSHIBA is not responsible for any incorrect or incomplete information. Information is subject to change at any time without notice.
關鍵字搜尋
參數搜尋
線上庫存查詢跟購買
儲存產品目錄
選擇應用
Find everything you need for your next product design. Simply select an application and click through to the block diagram to discover our semiconductor solutions.
新產品/新聞
Up to what level of current can be used at the switch section of a photorelay? Also, for a pulsed current or AC current, what happens?
A current to be used should be at a level of current below the value specified with “ON-State Current ION” for the absolute maximum rating in the technical documents. In addition, since derating by temperature Ta is applied to ION, the level may become equal to or lower than the above value. Care should be taken. Even for a pulsed current and AC current, a current must be used with a value not exceeding the value for ION with respect to both the current peak value and the current effective value.
開啟新視窗